STARFRIT 024604 Instrucciones De Uso página 23

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
The pressure cooker is equipped with safety feature that will advise you and shut the
unit down if an abnormal condition is encountered during pressure or slow cooking.
An error signal will be displayed on the control panel. Depending on the error, audible
beeping may be heard. Once the problem has been identified unplug the unit and
contact the customer service if no solution can help in the following table.
DESCRIPTION
Lid does not lock or steam air
escapes from the rim of the lid.
Air escapes from the float valve.
Cannot open the lid after air
exhaust
Error code appear on the control
panel (E4)
Error code appear on the control
panel (E1, E2 or E3)
WARRANTY
1-YEAR LIMITED WARRANTY.
This warranty covers any defects in materials and workmanship for a period of one
(1) year from the date of the original purchase. Please retain your original receipt as
a proof of the purchase date. Any complaints must be registered within the warranty
period. The product will be repaired, replaced (parts or entire appliance) or refunded at
our sole discretion. Shipping charges may apply.
This warranty does not cover normal wear of parts or damage resulting from any
of the following:
Negligent use or misuse of the product including failure to clean the product regularly,
use for commercial purposes, accident, use on improper voltage or current, use
contrary to the operating instructions, disassembly, repair or altercation by anyone
other than a STARFRIT authorized service agent.
Stains, discoloration and minor scratches on the inside and outside of the utensil
constitute normal use, do not affect performance, and are not covered by this warranty.
Decisions as to the cause of damage are the responsibility of Starfrit. All decisions
will be final.
The sealing ring assemble is not properly installed in lid.
Reinstall the sealing ring, follow the instruction FIG. 4.
Make sure the float pressure valve is well place and install.
The float pressure valve is still up, press on the float
Air leakage, check if the seal is well placed. If the message
appears again, please contact Customer Service:
starfrit.com/en/contact-us
Please contact Customer Service:
starfrit.com/en/contact-us
SOLUTION
Refer FIG. 3.
pressure valve.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido