Measurement Display Mode - Nikon ProStaff 3i Manual De Instrucciones

Measurement display mode

Horizontal Distance mode and Actual Distance mode can be switched.
(Factory default setting is Horizontal Distance mode.)
Press and hold the MODE button, then immediately depress the POWER ON/Measurement button (less
than 2 seconds) to change the mode in the order shown below.
1. Turn on the power (Confirm the internal display is on).
2. Press and hold the MODE button, then immediately (less than 0.5 second) depress
the POWER ON/Measurement button for less than 2 seconds.
3. Release your finger from the POWER ON/Measurement button to switch the
Measurement display mode.
* If the buttons are not pressed in the correct order, switching will not take place.
* Switching the mode after measurement converts the results to the new mode.
* After the mode is set, measurements are performed in the new mode.
Horizontal Distance
Mode
Actual Distance
Mode
Horizontal Distance
Actual Distance
En
Es
Fr
Pt
11