Measurement; Diopter Adjustment - Nikon ProStaff 3i Manual De Instrucciones

Measurement

Caution — use of controls or adjustments or performance of procedures other than
En
those specified herein may result in hazardous radiation exposure.
Es
1. Preparing
Fr
Install a battery in the battery chamber. (See "Changing Battery")
Pt

2. Diopter adjustment

Adjust diopter to obtain a clear LCD indication in the viewfinder.
First, rotate the diopter adjustment ring counterclockwise until it comes to a complete
stop. Next, press the POWER ON/Measurement button to turn on the power (Confirm the
internal display is on). While looking through the eyepiece, rotate the diopter adjustment
ring clockwise until the LCD comes into focus.
If you rotate the ring too much, rotate it counterclockwise substantially then adjust it again.
If the diopter is not adjusted to correspond to your eyesight, you may not be able to
correctly aim at your subject.
3. Measuring
Before measuring, be sure to confirm each mode (Measurement display mode/Target
priority mode/Distance display unit) setting.
* Please refer to each section on how to set each mode.
1. Turn on the power (Confirm
the internal display is on).
(Automatic power shut-off after
approx. 8 sec. unattended.)
Immediately after power-on
(Initializing)
14
Stand-by
2. Aim at the target.
Position the target at the center
of the reticle.
Target aiming