Triton TQTRSS Instrucciones De Uso página 7

Operation
WARNING: ALWAYS wear appropriate personal protective equipment, including eye
protection when working with this tool.
WARNING: This sander is NOT suitable for wet sanding.
Switching ON & OFF
WARNING: NEVER touch the Sanding Sheet when the tool is switched 'ON'.
Note: Always use clamps to secure your workpiece to the workbench wherever possible.
• Always grip the sander firmly using the handles provided
• To start the sander, press 'I' on the ON/OFF Switch (1)
• To stop the sander, press '0' on the ON/OFF Switch
Sanding tips
• Do not bring the sander into contact with the workpiece until the motor has gained full
speed. Remove the sander from the workpiece before stopping the machine
• Always start with a coarse grit paper, and work through progressively to finer grit papers
until the desired finish is achieved
• Only apply moderate pressure to the sander. Pressing too hard onto the work surface may
overheat the motor or damage the workpiece
• Sand evenly over the work surface; as the machine works in an orbital motion it is not
necessary to work with the grain
• Only use the sander 'flat on' to the workpiece. Tilting the sander onto its edge will damage
your work
WARNING: Do not allow the sandpaper to completely wear down before replacing it.
Failure to observe these precautionary measures can lead to damage to the base of the tool.
Accessories
• A full range of accessories including sanding sheets is available from your Triton stockist
• Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: Always disconnect from the power supply before carrying out any
maintenance/cleaning.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should
be carried out by an authorised Triton service centre. This advice also applies to extension
cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the tool's service life. Clean the body of your tool with a soft brush, or dry
cloth. If available, use clean, dry, compressed air to blow through the ventilation holes
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: tritontools.com/en-GB/Support
Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
EN
7