Festool HKC 55 EB Manual De Instrucciones página 19

curacy. The saw retreats automatically into the ini-
tal position.
 The splinterguard must be bedded in before the
first use, see chap. Guide rail.
Every time before use, check that the cross
cutting guide rail is retracted correctly and
have it repaired, if necessary. Never use if
automatic retraction is not operating cor-
rectly.
Connect saw to the cross cutting guide rail
Slide saw onto the cross cutting guide rail in

sawing direction.
The saw engages in the sliding block [9-2] .
The quick fastener [9-1] locks in behind the saw
table.
The saw is securely connected to the cross cutting
guide rail.
9
2
1
9-1
9-2
Loosen saw from the cross cutting guide rail.
Push saw forward slightly in sawing direction.

Turn quick fastener [9-1] to the front.

Remove saw towards the rear against the saw-

ing direction.
10
10-1
10-4
10-3
Procedure for compound mitre saws
Open knob at adjustable stop [10-2].

Adjust angle at the scale [10-4].

Close knob at adjustable stop [10-2].

Adjust depth and angle of the saw, see chap.

Adjusting the cutting depth and Adjusting the
cutting angle.
Adjust the guide play between the saw table and

the track rail using the two adjustable jaws [10-
3].
The saw must glide easily across the rail.
Place the adjustable stop [10-2] and the fixed

stop against the work piece and position the
track rail.
Switch saw on.

Push saw in direction of cutting.

Pendulum guard opens. Saw section.
10-2
19