Adjust Pendulum Guard; Adjusting The Cutting Angle - Festool HKC 55 EB Manual De Instrucciones

Adjusting the cutting depth
The cutting depth can be set at 0 - 2-1/8" (0-
55 mm).
Press cutting depth adjustment [3-1].

Pull up or push down saw at main handle.

Cutting depth without guide rail/cross cut-
ting guide rail
max. 2-1/8" (55 mm)
Cutting depth with guide rail/cross cutting
guide rail
+FS
max. 1-15/16" (50 mm)
+FS

Adjusting the cutting angle

 The saw table must be on an even surface when
adjusting the cutting angle.
between 0° and 50°:
Open knob [4-2].

Swivel sawing unit to the desired cutting angle

[4-1].
Close knob [4-2].

 Both positions (0° and 50°) are set at the factory
and can be readjusted by the after-sales service
team.
 For angled cuts, the cutting depth is smaller
than the value displayed on the cutting depth
scale.
14
4
3
Risk of injury! Sharp edges! The pendulum
guard swings back quickly in the event of
sudden release.
3-1
For difficult cuts with large angles and for plunge
cuts (see chap. Sawing cut-outs (plunge cuts))
and for
chap. Changing the saw blade),
guard must be opened [1-6] with the retractor lever
[1-4].
Risk of injury
Always disconnect the battery pack before per-

forming any type of work on the machine!
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-

tive.
Wear protective gloves.

50°
0°

Adjust pendulum guard

replacement of saw
Changing the saw blade
WARNING
CAUTION
0° - 50°
4-1
4-2
47°
blade (see
the pendulum