Service And Maintenance - Festool HKC 55 EB Manual De Instrucciones

Procedure
Adjust cutting depth, see chap. Adjusting the

cutting depth.
Press lever [8-1] down.

Sawing unit swivels upwards to plunge-cut po-
sition.
Hold retractor lever [8-2] downwards as far as

stop.
Pendulum guard [8-4] opens and the saw blade
is exposed.
Position saw on workpiece and position against

a stop (kickback stop).
Switch on saw.

Slowly press down saw to the set cutting depth

until the saw engages, release retractor lever
[8-2] and push forward in cutting direction [8-
9].
The notch [8-3] indicates the absolute rear cutting
point of the saw blade (Ø 6-1/4" (160 mm)) when us-
ing the saw at maximum cutting depth with the
guide rail.
WARNING
Any maintenance or repair work that requires
opening of the motor or gear housing should only
be carried out by an authorised Customer Service
Centre (name supplied by your dealer)!
Maintenance or repair work carried out by an

unauthorised person can lead to the wrong con-
nection of the power cord or other components,
which in turn can lead to accidents with serious
consequences.
8-4
8-9

Service and maintenance

Certain cleaning agents and solvents are harmful
to plastic parts.
Some of these include, but are not limited to:

Gasoline, Acetone, Methyl Ethyl Ketone (MEK),
Carbonyl Chloride, cleaning solutions containing
Chlorine, Ammonia, and household cleaners
containing Ammonia.
Risk of injury, electric shock
Always disconnect the battery pack from the

machine before any cleaning or maintenance!
All maintenance and repair work which requires

the motor housing to be opened, must only be
carried out by an authorised service workshop.
8-3
8-8
CAUTION
WARNING
8
8-1
8-2
8-5
8-6
8-7
17