Operating; Start-Up; Switching On And Operating The Unit - Silvercrest 99641 Instrucciones De Manejo

5 Operating

5.1 Start-up

The massage cushion has two functions for effective treatment: fingertip massage and heat. The
heat function can also be used without the shiatsu massage.
1. Place the neck massage cushion
back with the strap.
2. Sit on the chair and check that the cushion is in the position you want.
3. Connect the power unit
Ensure that the power supply is easily accessible.
4. Use the buttons on the control unit
Do not use the unit for more than 15 minutes. After approx. 15 minutes, the unit will switch off
automatically. Always allow the unit to cool down fully before you use it again.

5.2 Switching on and operating the unit

1. Switch on the device by pressing Ein/Aus button
2. Press the button
LED lights up. To change the direction of rotation, press the
LED goes out and the
the button you last pressed (
The massage can also be started in the other direction.
3. The heat function can be activated at any time with the shiatsu massage. Press the Heat
button to activate the function; the red LED lights up. The heat is radiated through the
massage heads
LED goes out.
NOTE
The massage intensity declines when the heat function is switched on.
5.3 To switch off the device
1. Press the Ein/Aus button
2. After each use, switch the device off using the Ein/Aus button
from the mains socket.
on the back of a high-backed chair and fasten it to the
and the massage cushion and plug in the power unit to the mains.
to operate the massage cushion.
to activate the massage function with outward rotation. The blue
LED lights up blue. To switch off the massage function, press
or ) again.
. Press the Heat button
. The blue power LED goes out.
Operating
. The blue power LED illuminates.
again to deactivate the heat function; the red
and remove the power unit
GB
button . The
33