Cleaning the textile cover and straps
1) Loosen the hook-and-loop hand support and the abductor from the
orthosis.
2) Remove all hook-and-loop closures and the tubular frame.
3) Wash the textile cover and straps in warm water at 30 °C with a standard
mild detergent. Rinse thoroughly.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
5) The textile cover can be dried in a tumble dryer at a low temperature set
ting (gentle cycle).
6) After drying, pull the textile cover over the tubular frame. Refasten the
hand support, hook-and-loop closures and abductor on the orthosis with
hook-and-loop.
Optional: 29A217 spare cover available. We recommend using this when
cleaning the textile cover.
7 Disposal
Dispose of the product in accordance with national regulations.
8 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
8.1 Local Legal Information
Legal information that applies exclusively to specific countries is written in
the official language of the respective country of use after this chapter.
8.2 Liability
The manufacturer will only assume liability if the product is used in accord
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor
ised modification of the product.
8.3 CE conformity
The product meets the requirements of Regulation (EU) 2017/745 o n medic
al devices. The CE declaration of conformity can be downloaded from the
manufacturer's website.
20