Stihl RL-MM Manual De Instrucciones página 6

!
Warning!
Power tool noise may
damage your hearing.
Wear sound barriers (ear
plugs or ear mufflers) to
protect your hearing.
Continual and regular
users should have their hearing checked
regularly.
Protect your hands with
gloves when handling the
power tool and the cutting
attachment. Heavy-duty,
nonslip gloves improve
your grip and protect your
hands.
Clothing must be sturdy
and snug-fitting, but allow
complete freedom of
movement.
Avoid loose-fitting jackets,
scarves, neckties, jewelry,
flared or cuffed pants,
unconfined long hair or
anything that could
become caught on
branches, brush or moving parts of the
unit.
RL-MM
Wear long pants made of heavy material
to protect your legs. Do not wear short
pants, sandals or go bare foot. Secure
hair so it is above shoulder level.
Good footing is most
important. Wear sturdy
boots with nonslip soles.
Steel-toed safety boots
are recommended.
Wear an approved safety
hard hat to reduce the risk
of injury to your head
when there is a danger of
head injuries.
THE AERATOR MULTITOOL
For illustrations and definitions of the
aerator MultiTool parts see the chapter
on "Main Parts".
!
Warning!
Never modify a MultiTool in any way.
Only attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL power tool
models are authorized. Although certain
unauthorized attachments may fit on the
STIHL power tool, their use may, in fact,
be extremely dangerous.
English / USA
THE USE OF THE AERATOR
Transporting the aerator
!
Warning!
Always turn off the engine and make
sure the rotating attachment has
stopped before putting an aerator down.
When transporting your power tool in a
vehicle, properly secure it to prevent
turnover, fuel spillage and damage to the
aerator.
Preparations before using the power
tool
Before starting work, set the handlebar
to the normal working position and
tighten it down firmly with the rotary
knob. See chapter on "Adjusting the
Handlebar" in the MultiEngine
instruction manual.
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger interlock (and if applicable stop
switch, cutting tool and deflector).
The throttle trigger must move freely and
always spring back into the idle position.
The cutting tool must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged parts.
5