Stihl RL-MM Manual De Instrucciones página 15

English / USA
Adjusting Position of Gearbox
: Loosen clamp screws on gearbox.
: Turn gearbox 180°.
: Line up the gearbox in the correct
position.
: Tighten down the two clamp screws
on the gearbox in the following
sequence:
– Tighten first screw moderately.
– Tighten second screw moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
14
Mounting the MultiTool
: Arrange the blades in the order they
will be fitted on the shaft, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox
and blades. Make sure the arrows
point in the same direction.
6
5 4
: Rotate the inner, right-hand blade
(4) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
The hub of the inner blade is larger
than that of the outer blade.
: Rotate the outer, right-hand blade
(5) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
: Insert and engage spring clip (6) in
the hole in the shaft – fold the spring
clip flat against the blade.
: Use the same procedure to mount
the blades on the left-hand side.
RL-MM