Angelo Po 1G1FA0E Manual De Uso página 50

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the injector (D) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
IT
ADJUSTING TOP BURNER PRIMARY AIR
To carry out this operation, proceed as follows.
GB
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
DE
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screw (D) and lift the burner support
FR
ES
English
B
A
B
A
5 - Fully screw the injector.
6 - After making the setting, seal the screw with
paint.
7 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
C
(E) as far as it will go.
5 - Tighten the screw (D) and restore the initial
conditions when the operation is complete.
E
C
- 22 -
D
IDM-39618301200.tif
D
IDM-39618301400.tif