Outdoor Unit; Connection To A Television Set; Via Hdmi Cable; Via Scart Cable - TechniSat DiGYBOXX T4 Instrucciones De Funcionamiento

4.1 Outdoor unit

a
Connect the cable that extends from the terrestrial antenna (roof antenna or
indoor antenna) to the terrestrial antenna input on the receiver.
Use a roof antenna, if possible. An indoor antenna may be sufficient if you have
favourable reception conditions. When using an active antenna,
the antenna feed must be switched on (section 6.2.4).

4.2 Connection to a television set

4.2.1 Via HDMI cable

b Use an HDMI cable to connect the receiver (HDMI output) with the television set
(HDMI input).
If your television set is appropriately equipped, it will automatically switch to the HDMI
input when you turn on the digital receiver.

4.2.2 Via SCART cable

c Use a SCART cable to connect the receiver (TV SCART socket) with the televi-
sion set (SCART socket). If your television set is appropriately equipped, it will auto-
matically switch to AV (and therefore to DTT mode) when you turn on the digital
receiver.

4.2.3 Via RF cable

In order to continue receiving existing analogue programmes, the digital receiver must be
connected to the antenna input on your television set. This connection is used exclusively
to transmit analogue programmes to the television set. In order to display DTT programmes
on your television set, you must make the HDMI connection or the SCART connection (see
sections 4.2.1 and 4.2.2).
d Use a suitable TV connection cable to connect the receiver (antenna output) with
the antenna input on your television set.

4.3 Video recorder (VCR)

e Connect the video recorder to the VCR SCART socket. During playback, the video
recorder sends a switching signal to the digital receiver. The video recorder's signal
is thereby automatically received by the TV set. If your video recorder does not
provide switching voltage, use the AV button to switch your digital receiver to the
external AV input. Pressing this button again will return the device to normal opera-
tion.

4.4 Hi-fi amplifier

4.4.1 Analogue

f
To obtain the best possible sound quality, you can connect the digital receiver to
a hi-fi amplifier. To do so, use a suitable cable to connect the right audio and
left audio RCA jacks on the digital receiver with an input on your hi-fi amplifier
(e.g CD or AUX; Note: the phono input is not suitable).
11