Operation; Switching On/Off; Programme Selection; Using The Programme Up/Down Buttons - TechniSat DiGYBOXX T4 Instrucciones De Funcionamiento

Confirm by pressing OK.
>
The Antenna adjustment menu appears.
Now use the left/right arrow buttons to select the channel with the weakest
>
reception signal.
> Adjust the antenna so that both bars show the strongest level.
Red bar
Yellow bar
Green bar

7 Operation

7.1 Switching on/off

Switch the digital receiver on by pressing the On/Standby button on the device or
>
remote control.
> Press this button on the device or remote control again to switch the device off.
> The device is now in standby mode, which is indicated by a red LED on the display.

7.2 Programme selection

7.2.1 Using the programme up/down buttons

Use the PROG +/- buttons on the receiver or remote control to move up/down one
>
programme position at a time.

7.2.2 Using the number buttons

Use the number buttons to enter the desired programme number.
>
For example:
1
1, then 4
2, then 3,
Poor reception
Good reception
Very good reception
For programme position 1
For programme position 14
and then 4
For programme position 234
22