Time Offset Selection; Gmt Time Offset (Hrs.); Antenna Feed 5 V; Automatic Standby - TechniSat DiGYBOXX T4 Instrucciones De Funcionamiento

6.2.2 Time offset selection

Your device is equipped with a clock. This clock is synchronised to Greenwich Mean Time
via DTT.
automatic
Use the left/right arrow buttons to set to automatic.
>
The local time will now be automatically set according to the country that you selected
(section 6.2.1).
manual
Use the left/right arrow buttons to set to manual.
>
Now you can manually adjust the local time in the GMT time offset (hrs.) menu item.

6.2.3 GMT time offset (hrs.)

Use the left/right arrow buttons to set the time difference in relation to
>
Greenwich Mean Time.

6.2.4 Antenna feed 5 V

When you use an active antenna, you need to switch on the antenna feed (5 V/30 mA).
This supplies the antenna with power through the terrestrial antenna input.
Highlight this row and use the left/right arrow buttons to switch the antenna
>
feed on or off.
In the event of an overload or short-circuit in the antenna feed, this will be automati-
cally switched off. If this happens, fix the error and then switch the antenna feed back
on.
Press the EXIT button to return to the Settings menu or press the MENU button to
>
return to normal operation. Your settings are automatically saved.

6.2.5 Automatic standby

After the preset time has elapsed, the automatic standby circuit automatically switches the
device to standby mode, provided you have not operated any of the device's controls during
this period.
Use the left/right arrow buttons to select a period of time after which the device will
>
automatically switch to standby mode.

6.3 Audio/Video settings

You can make additional settings in the Audio/Video settings menu so that the digital
receiver is configured for your television set.
Use the MENU button to open the Main menu.
>
Highlight the Settings row using the up/down arrow buttons.
>
Confirm by pressing the OK button.
>
The Settings submenu appears.
18