Jøtul FS 166 Manual De Instrucciones página 43

Fig. 6
B
Mount the four cassette legs (Fig. 6 A).
1.
2. Screw the foot screws (Fig. 6 B) through the foot. Adjust
lenght to approx. 15 mm (see Fig. 1 and Fig. 13).
3. Stand the product carefully up.
4. Reposition the previously removed heat shield (see Fig. 5).
Fig. 7
Unscrew the upper heat shield at the rear (Fig. 7 A). Turn it
1.
upside down and screw it firmly in position using the same
screws it was fastened with before.
2. If top smoke outlet: Mount the heat shield for flue pipe
(Fig. 7 B).
A
B
A
Fig. 8 A
NB! Hole in floor for external air.
Fig. 8 B
D
Assemble the stand. The stand consist of bottom plate (Fig.
1.
8 B-A), 4 legs (Fig. 8 B-B) and top plate (Fig. 8 B-C).
2. It is very important that the legs are mounted as shown in
figure 8 B-D.
3. Place the stand at its final position and make sure a gap of
min. 50 mm to the wall.
The floor and stand has to be completely level (Fig. 8 B-E).
4.
This is extremely important to ensure that the rest of the
installation is correct.
ENGLISH
C
B
50 mm
A
E
43