Jøtul FS 166 Manual De Instrucciones página 44

ENGLISH
Fig. 9
Bracket 1
Bracket 4
Bracket 5
Fig. 10
NB!: Do not use corner stones marked «223628» before the
fourth layer.
1. Fit the first layer of soap stone on the bottom plate. Use
bracket 4 and bracket 6 under to hold them in place.
2. Make sure the layer is level and placed correct on the bottom
plate (Fig. 10 A). Use a rubber mallet to adjust the stones.
3. Place the front stone and corner stones of the second layer
using bracket 1 (Fig. 10 B).
44
Bracket 2 Bracket 2
Bracket 3
Bracket 6
B
A
3mm
Fig. 11
1. Position the burn chamber on the stand. Make sure that the
burn chamber is positioned stably.
2. Refit all the parts that were removed for easier handling
of the insert.
Mount the first rear plate to bracket 6 that is placed under
3.
the first layer of soap stone.
Mount bracket 3 from the inside through the back plate (Fig.
4.
11 A). Use a hammer and knock it gently into the soap stone.
5. Place the side stones of the second layer between the corner
stones and the rear plate. Use bracket 3 to hold it in place
(Fig. 11 B).
6. Make sure everything is level.
Fig. 12
Remove the lower cover (Fig.12 A).
1.
2. Fit the decorative frame over the door and hook it over the
front (Fig. 12 B).
3. Attach the trim panel with the same screws as those used
for the lower cover (Fig. 12 C).
Remove the M8 screw provided (Fig. 12 D).
4.
B
A
D
B
C
A