Maintenance; Introduction; Maintenance Chart; C.maintenance Tips - Quickie SR45 Manual De Instrucciones

E N G L I S H
XI. MAINTENANCE
A. INTRODUCTION
1. Proper maintenance will improve performance and extend
the useful life of your chair.
2. Clean your chair regularly. This will help you find loose or
worn parts and make your chair easier to use.
3. Repair or replace loose, worn, bent or damaged parts
before using this chair.
4. To protect your investment, have all major maintenance and
repair work done by your authorized supplier.
WARNING
If you fail to heed these warnings your chair may fail
and cause severe injury to the rider or others.
1. Inspect and maintain this chair strictly per maintenance chart.
2. If you detect a problem, make sure to service or repair the
chair before use.
3. At least once a year, have a complete inspection, safety check
and service of your chair made by an authorized supplier.
B. MAINTENANCE CHART
CHECK...

Tire inflation level

Wheel locks

All fasteners for wear and tightness

Armrests

Axle and axle sleeves

Quick-release axles

Wheels, tires and spokes

Casters

Anti-tip tubes

Frame

Rollers

Tilt cables and plunger

Rocker arm

Service by authorized supplier
C. MAINTENANCE TIPS
1. Axles & Axle Sleeves:
Check axles and axle sleeves every six months to make sure they
are tight. Loose sleeves will damage the axle plate and will affect
performance.
2. Tire Air Pressure:
Check air pressure in pneumatic tires at least ONCE A WEEK. The
wheel locks will not grip properly if you fail to maintain the air
pressure shown on tire sidewall.

D.CLEANING

1. Paint Finish
a. Clean the painted surfaces with mild soap at least once a
month.
b. Protect the paint with a coat of non-abrasive auto wax every
three months.
2. Axles and Moving Parts
a. Clean around axles and moving parts WEEKLY with a slightly
damp (not wet) cloth.
b. Wipe off or blow away any fluff, dust or dirt on axles or mov-
ing parts.
NOTE– You do not need to grease or oil the chair.
3. Rocker arm and Carriage Assembly
a. Wipe the rocker arm's lower surface WEEKLY with a slightly
damp (not wet) cloth.
b. Check the plunger on each side weekly, dismantle and clean
if needed. See Section IX.-G. for cable adjustment.
E. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts
may rust or corrode.
2. Before using your chair, make sure it is in proper working
order. Inspect and service all items on the "Maintenance
Chart".
3. If stored for more than three months, have your chair
inspected by an authorized supplier before use.
23
XI. M INTEN NCE
118611 Rev. B