Lap Belt Instructions; Check-Out - Quickie SR45 Manual De Instrucciones

E N G L I S H
S. LAP BELT INSTRUCTIONS
NOTE– Lap belts are fitted as positional aids, and are not suitable as transportation restraints.
34
Positioning Belt Kit
The positioning belt kit contains:
• one positioning belt (A)
• three tri glide buckles (B)
• two cable ties (C)
1. To assemble the positioning belt, take the positioning belt strap and thread through the
tri-glide. Repeat on both ends of positioning belt.
2. To fit the positioning belt to the chair, take the positioning belt strap and wrap around
the back post.
3. Thread the positioning belt back through the tri-glide to form a loop around the back
post. Thread positioning strap through tri-glide as shown.
4. To secure the positioning belt to the chair. Take one of the cable ties supplied and
thread through the positioning belt strap. Then wrap around the frame and fasten
together. DO NOT over tighten positioning belt. Repeat steps 2-4 with both ends of
positioning belt.
5. To adjust the positioning belt use the tri-glide buckles and the fastening buckle.
6. The positioning belt should be adjusted so the fastening buckle is situated in the middle
of the stomach.
7. The positioning belt should be adjusted so a hand can be placed between the user and
the belt. 37
The positioning belt must only be fitted by an approved Sunrise Medical deal-
er/agent. The positioning belt should only be adjusted by a professional, or a
Sunrise Medical approved dealer/agent.
The positioning belt must be checked on a daily basis to ensure it is adjusted
correctly (see step 6) and is free from any obstruction or adverse wear.
Sunrise Medical does not encourage the transportation of any person in a vehi-
cle using this positioning belt as a method of restraint. Please see Sunrise
Medical transit booklet for further advice on transportation.
Maintenance
Check lap belt and securing components at regular intervals for any sign of frays or damage.
Replace if necessary.
The lap belt should be adjusted to suit the end user as detailed above. Sunrise Medical
NOTE–
recommends that the length and fit of the belt be checked on a regular basis to reduce
the risk of the end user inadvertently re-adjusting the belt to an excessive length.
T. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should also perform smoothly. If you have any problems, follow these procedures:
1. Review assembly and adjustment sections to make sure the chair was properly pre-
pared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise Medical customer service.
See the introduction page for details on how to contact your authorized supplier or
Sunrise Medical customer service.
35
36
WARNING
WARNING
WARNING
21
IX. SET-UP & DJUSTMENT
34
B
C
A
35
36
37
118611 Rev. B