User Instruction - Nederman MagnaTrack LL Manual De Instrucciones

GB

User Instruction

Connection
1. Open the station door and start the exhaust extraction
fan (as an alternative the fan can be connected to an
automatic start/stop-
system).
2. Reverse the vehicle
in so that the exhaust
pipe is just outside the
station door.
A manual disconnection
from the anchor plate is
possible with a switch on
the electromagnet unit.
Disconnection
1. Make sure the extraction hose is connected to the
exhaust pipe and that it is firmly fastened to the anchor
plate on the vehicle's side.
2. Start the fan and open the station door. Drive the vehic-
le straight out from the garage with a maximum speed of
20 km/h (12 mph). The hose automatically disconnects
when the vehicle is driven out.
The flexible hose can withstand 150 °C (300 °F) for
continuous running and 180°C (355 °F) for short
periods. Use at higher temperatures will shorten
the life of the product. Therefore, avoid tasks that
require extended periods of continous running
which will generate high exhaust temperatures.
20
MagnaTrack LL
3. Locate the nozzle
of the flexible hose
on the exhaust pipe.
Fasten the electro-
magnetic unit onto
the anchor plate
located on the side of
the vehicle.
Fitting the
standard or
HB-nozzle.
max. 1 m
max. 3 ft
Alternative
fitting of
HB-nozzle.
WARNING!
Risk of personal injuries and/or product damages.
The system must only be used in combination with the
anchor plate which should be mounted on the vehicle.
The system must not be used when working on the
vehicle´s fuel system, when recharging the batteries
or whenever there is a risk for inflammable dust or
explosive gases.
The system must be disconnected and must not be
exposed for water when washing the vehicle.
The system is designed for use only in the direction
of the length of the rail.
The system must not be used for other purposes than
extracting exhausts.
Check that there is enough suction capacity in the
exhaust hose before it is connected to the vehicle ex-
haust pipe. If needed, check the fan impeller rotation
direction and/or damper function.
Check that the nozzle is correctly fitted to the exhaust
pipe after the vehicle has been moved.
Check that the hose or nozzle will not snag on any
protruding parts on the vehicle.
4. Reverse the vehicle into
its parking space. The hose
should always be con-
nected to the exhaust pipe
while the vehicle is parked
in the station.