Installation Checklist - Nederman MagnaTrack LL Manual De Instrucciones

Electrical installation and wiring diagram
Connection to the mains should be carried out by a qualified electrician.
Disconnection
magnet
24 V DC
Disconnection box
Circuit breaker
Electro magnet
VDR

Installation checklist

When the mechanical assembly, fan connection and electrical
installation of MagnaTrack is complete, the system is ready for use
after double-checking the following points:
• Check the disconnection procedure. The extraction hose
should disconnect from the exhaust pipe immediately before
the station door opening at normal speed, not more than 20
km/h (12 mph). Adjust the disconnection position by moving
the disconnection magnet on the front rail (see assembly
instructions, page 16, point 8).
If the disconnection does not work at
all in the forward direction, move the
contact in the disconnection box
according to this figure.
MagnaTrack LL
Transformer
Secundary voltage: 26V AC
Fuse Capacity: 5VA
Horizontal
hose with
cable
Ground
cable
Connection box
230 V
Block, 3 - 4
connected at
delivery.
115 V
Block, 2- 4 & 3 - 5
connection should
be carried out by
electrician.
• Check that the hose lifts away correctly after
disconnection and that it does not touch the station
floor. When required, adjust the balancer lifting
power according to the instructions in the mainte-
nance instructions (page 21).
• Check that the hose does not catch any part of
the vehicle or the station door.
• Check the air flow (800 - 1200 m
for 6" nozzle and 400 - 800 m
nozzle at idling speed are normally recommended) in
the nozzle opening with an air flow indicator.
If required, check the fan impeller rotation direction
and/or damper function.
• Check the electrical installation (disconnection
box, micro switch, magnet) according to the
wiring diagram.
Service breaker,
not included in
the package.
PE
N
L
PE
N
L
PE
N
L
/h (500 - 700 cfm)
3
/h (250 - 500 cfm) for 5"
3
GB
PE
19