General Warnings; First Ignition Settings; Date/Time; Language - Dal Zotto INSERTO 700 AIR Manual Del Usuario

GENERAL WARNINGS

Advice to follow for the rst start-ups of the product:
During the rst hours of operation, there may be some smoke or
odours, but they are due to the normal "thermal break-in" process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š Ventilate the room well
Š If present, remove any majolica parts from the top of the
product
Š Activate the product at the maximum power and temperature
Š Avoid remaining in the room for a long time
Š Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.

FIRST IGNITION SETTINGS

Once the power cable at the back of the generator has been connected, move the switch, also located on the back, to (I).
The switch at the back of the generator powers the generator board.
The generator remains o and an initial screen appears on the panel, displaying OFF.

DATE/TIME

This menu allows the date and time to be set.
To set: OK > SETTINGS > DATE/TIME.

LANGUAGE

This menu allows the preferred language to be selected.
The languages available are: Italian - English - German - French - Spanish - Portuguese.
To set: OK > SETTINGS > LANGUAGE.

DEGREES

This menu allows you to set the desired unit of measurement.
To set: OK > SETTINGS > DEGREES
IT IS FORBIDDEN TO USE THE DEVICE WITHOUT A PARTITION A AND FLAME
GUARD B .
REMOVAL WILL COMPROMISE THE SAFETY OF THE PRODUCT AND RESULT IN
THE IMMEDIATE NULLIFICATION OF THE WARRANTY PERIOD.
IN THE EVENT OF WEAR OR DETERIORATION, REQUEST THE PART'S
REPLACEMENT FROM THE AFTER SALES SERVICE
REPLACEMENT DOES NOT FALL WITHIN THE PRODUCT WARRANTY AS THE
PART IS SUBJECT TO WEAR .
60
Before turning on the product, it is necessary to perform the
following checks:
Š If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š The pellet hopper must be completed loaded
Š The combustion chamber and the burn pot must be clean
Š Make sure that the re holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š Check that the power cord is properly connected
Š The bipolar switch (if present) must be set to position "1".
ENGLISH
A
B