LRP S8 REBEL Manual De Instrucciones página 18

SOLUCIÓN DE PROBLEMAS
Problem
Engine does not start
Engine stops after a
short time after glow
plug igniter has been
disconnected
Performance decreases
after reaching operating
temperature or engine
stalls from time to time
Engine still keeps running
at high RPM for a mo-
ment when you release
the throttle
Bad control of the Car
P . 18
Reason
Glow plug defective
glow plug does not work properly
Engine is set too rich
(too much fuel, hits back)
Engine is too lean (too little fuel, does not
start)
Engine doesn`t suck in the fuel
Glow plug defective
Bad fuel
bad carburetor setting
Dirt in fuel or carburetor
Fuel line damaged
loose glow plug or cooling head
Air filter old or dirty
Engine is set too lean
Glow plug defective or wrong type
Engine runs too hot
Shims under burnroom wrong
Bad carburetor setting
glow plug, wrong type
Shims under burnroom wrong
Batteries of transmitter or receiver are
weak or empty
Problems with the range
TROUBLE SHOOTING GUIDE
Solution
a) replace glow plug
a) check the condition of the glow plug
b) check the glow plug igniter
a) check carburetor settings
b) unscrew the glow plug completely and
pull the pull start several times
a) check carburetor settings
b) repeat tuning procedure
a) check the fuel line for possible damage
b) check the carburetor setting
a) replace glow plug
a) replace fuel by fresh and correct type
a) check the carburetor setting
b) repeat tuning procedure
a) clean fuel line
b)clean and check the carburetor
a) replace fuel line
a) tighten glow plug or cooling head
a) clean or replace air filter
a) check the carburetor setting
b) repeat tuning procedure
a) replace the glow plug by a correct type
a) run-in process is not completed
a) check number of shims
a) open mid range needle 1/4 turn at a time
and re adjust idle-speed
b) set idle speed lower
a) replace the glow plug by a correct type
a) check number of shims
a) install fresh batteries
b) charge your rechargeable batteries
a) Check antenna of transmitter/receiver