Especificaciones Técnicas; Comprobaciónes Antes De Usar Su S8 Rebel Tx - LRP S8 REBEL Manual De Instrucciones

Ocultar thumbs Ver también para S8 REBEL:
Tabla de contenido

Publicidad

GUÍA DE INICIO RÁPIDO
INVERSOR SERVOS DIRECCIÓN
STEERING REVERSE FUNCTION
Si la dirección de su S8 Rebel trabaja de forma diferente a la mostrada en la imágen, utilice la
función inversor de servo de su emisora.
If the steering of your S8 Rebel is working different to the picture, please use the steering reverse
function on your transmitter.
ESPECIFICACIONES TÉCNICAS
Longitud / Length
Distancia entre ruedas / Wheel base
Tipo /Drive System
Relación de transmisión / Gear Ratio
Piñonaje / Gearing
Diámetro rueda / Diameter of wheel
Ancho rueda / Width of wheel
COMPROBACIÓNES ANTES DE USAR SU S8 REBEL TX
Antes de utilizar su modelo compruebe los puntos siguientes:
a) Extienda la antena y conecte la emisora.
b) Conecte las baterías al receptor.
c) Compruebe la correcta instalación de la antena del modelo, entonces conecte
el interruptor de las baterías del receptor.
d) Compruebe todas las funciones de la emisora y el coche antes de empezar.
Compruebe los servos.
e) Compruebe siempre el alcance de la emisora antes de usar el modelo.
f) Arranque el motor.
g) Compruebe el servo de dirección y triméelo si el modelo no va recto.
h) Después de correr, desconecte primero el interruptor del receptor, desco-
necte la batería del receptor y apague la emisora.
i) Tenga cuidado con la temperatura del motor.
PRECAUCIÓN: Puede estar muy caliente
j) Vacíe el depósito de combustible
k) Limpie el coche y compruebe que no esta dañado.
l) Aplique grasa o aceite a los rodamientos, suspensión, piñones, etc.
m) Guarde el coche y las baterías del receptor por separado cuando no lo vaya
a usar.
QUICKSTARTGUIDE
S8 REBEL TX
560mm
Ancho / Width
420mm
Alto / Height
190mm
380mm
4WD por palieres /4WD Shaft Drive
15:19 : 1 / RTR Ration 46 : 13
Módulo 1
145mm
61mm
CORRECTO
CORRECT
INCORRECTO
WRONG
CHECK LIST FOR USING YOUR S8 REBEL TX
a)
Pull-out the antenna and switch on the transmitter.
b)
Connect the Batteries to the receiver.
c)
Check the installation of the antenna wire (refer to Quickstart),
then switch on the receiver.
d)
Check all functions of the transmitter and the car before the start.
Check both servos.
e)
Always make a operating range check prior to use.
f)
Start the engine as it is explained in the guide.
g)
Check the steering servo and trim it, if the car does not run straight.
h)
After running, please switch off the car (please check the guide),
disconnect the battery from receiver and switch off the transmitter.
i)
Be careful with the temperature of the engine.
Attention: Motor will be very hot – risk of injury!
j)
Draining the fuel tank. (Consider the proper disposal of the
glow fuel.)
k)
Clean the car and check if the car is damaged.
l)
Apply grease or oil to bearings, suspension, gears, etc.
m)
Store the car and the receiver batteries separately
when not using it.
P . 7

Publicidad

Tabla de contenido
loading

Tabla de contenido