Resetting The Appliance; Filling And Emptying The Well - Angelo Po 191BR1E Manual De Uso

RESETTING THE APPLIANCE

If the safety thermostat is
tripped, the appliance has
to be restored to the initial
working conditions as fol-
lows.
1 - Cut off the mains elec-
tricity supply using the
appliance's
switch.
2 - Allow the appliance to
cool for about 10 min.
3 - Raise the lid (A).
4 - Turn the handle (B)
clockwise to tilt the well
and allow access to the
safety thermostat
(C).
if the appliance is installed in the middle of
a bank, remove the front panel (D) for ac-
cess to the safety thermostat (C).
5 - Press the button (E) of the safety thermo-
stat to restore the electricity supply.
6 - Restore the initial conditions after completing
the operation.
IT

FILLING AND EMPTYING THE WELL

GB
Filling
DE
Important
Before proceeding with this operation
FR
check that the well is not raised and resting
firmly on fixed part of appliance.
ES
1 - Raise the lid (A).
2 - Press the switch (B) to fill the well with water by
NL
means of the spout (C).
3 - Press the switch (B) once the water has
reached the level mark (D).
4 - Close the lid (A).
English
C
master
D
A
E
B
C
- 10 -
IDM-39616301400.tif
A
D
B
IDM-39616300800.tif