Optional Equipment; Disposal; Battery Disposal; Ec Declaration Of Conformity - RIDGID A-Frame Manual De Instrucciones

A-Frame Fault Locator
cator must be performed by a RIDGID Inde -
pendent Service Center. Use only RIDGID
service parts.
For information on your nearest RIDGID Inde -
pen dent Service Center or any service or repair
questions, see Contact Information Section in
this manual.

Optional Equipment

WARNING
To reduce the risk of injury, only use ac-
cessories specifically designed and rec-
ommended for use with the RIDGID A-
Frame Fault Locator, such as listed below.
Catalog
No. Description
20973 RIDGID SeekTech 4" (100 mm)
Inductive Signal Clamp
57763 Ground Stake, FT-103
57768 Red and Black Test Leads, FT-103
96967 RIDGID NaviTrack II Locator
19238 RIDGID NaviTrack Scout Locator
22163 RIDGID SeekTech SR-60 Line Locator
21893 RIDGID SeekTech SR-20 Line Locator
44473 RIDGID SR-24 Line Locator with
Bluetooth ®
For a complete listing of RIDGID equipment
avail able for this tool, see the Ridge Tool Cata -
log online at RIDGID.com or see Contact
Information.

Disposal

Parts of this tool contain valuable materials
and can be recycled. There are companies
that specialize in recycling that may be found
locally. Dispose of the components in compli-
ance with all applicable regulations. Contact
your local waste management authority for
more information.
For EC Countries: Do not dispose
of elec trical equipment with house-
hold waste!
According to the European Guide -
line 2012/ 19/EU for Waste Elec trical
and Electronic Equipment and its
imple men tation into national legislation, elec-
trical equipment that is no longer usable must
be collected separately and disposed of in
an environmentally correct manner.
14
and GPS

Battery Disposal

For EC countries: Batteries must be recycled
according to the guideline 2006/66/EEC.
EC Declaration of
Conformity
The EC Declaration of Conformity (890-011-
320.10) will accompany this manual as a sep-
arate booklet when required.

FCC Statement

This equipment has been found to comply
with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable pro-
tection against harmful interference in a resi-
dential installation.
This equipment generates, uses, and can ra-
diate radio frequency energy and, if not in-
stalled and used in accordance with the in-
structions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment OFF
and ON, the user is encouraged to try to cor-
rect the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Consult the dealer or an experienced radio/ -
TV technician for help.
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is taken
to mean the capability of the product to function
smoothly in an environment where electro-
magnetic radiation and electrostatic discharges
are present and without causing electromagnet
interference to other equipment.
The RIDGID A-Frame Fault Locator
NOTI E
conform to all applicable EMC standards.
However, the possibility of it causing interfer-
ence in other devices cannot be precluded. All
EMC related standards that have been tested
are called out in the tool's technical document.
999-995-095.10_REV. A