Stiga RC 685 Manual De Instrucciones página 109

1. Turn the accelerator valve regulator on the handle frame to the maximum adjustable position
without any load, and check if speed counter shows the speed is 3300±50, and then turn the
accelerator valve regulator to the minimum adjustable position and check whether speed counter
shows the speed is 1800±100.
2. If the speed value displayed by the speed counter isn't within the said ranges, it is necessary to
adjust the gasoline engine.
Steps to adjust the engine:
1) Observe whether connection points of the accelerator cable are loose or have broken off, if so,
retighten them to their original places.
2) Turn accelerator valve regulator on the handle frame to the maximum adjustable position without
load, and then adjust the speed adjusting bolt of the gasoline engine's accelerator operation
mechanism to a proper position.
3) After long work, the user may adjust the fine-adjusting bolt of the accelerator cable to adjust the
engine.
7. Selection of gear shift position
- Three positions (four positions for some models)of the tiller's gear shift are available for
selection.
- Method to shift gear position:
1) Swivel the accelerator valve regulator clockwise to the extreme left position (minimum).
2) Release the clutch lever to disengage the clutch.
3) Move the shift lever to the position you need.
4) Hold tight the clutch lever, and the tiller will work on the gear shift position you have selected.
8