Ignition Control; Important - Stiga MP2 504 Series Manual De Instrucciones

use the machine until all the indications provided in
the "ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
Unpacking
4.1.1
Cautiously open the packaging, paying
1.
attention not to lose components.
Consult the documentation in the box,
2.
including these instructions.
Remove all the unassembled parts from the box.
3.
Remove the machine from the box.
4.
Dispose of the box and packaging in
5.
compliance with local regulations.
GRASS-CATCHER ASSEMBLY
4.2
The grass-catcher is supplied fully assembled.
Make sure all the components are
correctly assembled (ig. 3.A).
4.3 HANDLE ASSEMBLY
Open the handle to the working position carefully (ig. 4.A).
Insert the starter cable in the lower and upper
spiral and tighten the nut (ig. 4.B).
5. CONTROLS
5.1 HANDLE FOR MANUAL START
Enables manual starting of the engine (ig. 5.A).
ELECTRIC PUSH-BUTTON
5.2

IGNITION CONTROL

Enables electrical starting of
the engine (ig. 5.B).
5.3 THROTTLE CONTROL
Regulates the engine's r.p.m. (ig. 6.A).
The positions are indicated on the plate
showing the following symbols:
1. Full throttle. To be used always
when the machine is running.
2. Minimum: used when the machine
is suiciently warm during stationary
periods of operation.
3. "Choke" engaged. Used to turn
on the engine when cold.
5.4 SPEED CONTROL LEVER
The speed control lever allows the operator
to regulate forward gear speed (ig. 7.A).
The positions are indicated on the plate
showing the following symbols:
1. Maximum speed.
2. Minimum speed.
IMPORTANT The engine must be
running and the drive engaged when
switching from one speed to another.
Do not touch the converter control when the engine
is off. Doing this could damage the converter.
NOTE If the machine does not move forward with the
» position, simply move the lever to «
lever in the «
» and then immediately return to the «
ENGINE BRAKE LEVER / CUTTING MEANS
5.5
It is the lever that allows you to switch the engine
on and of whilst simultaneously engaging and
disengaging the cutting means (ig. 8.A).
5.6 DRIVE ENGAGEMENT LEVER
It engages the wheel drive and allows
the machine to move forward.
1. Drive engaged. Push the lever toward
the handle for forward movement (ig.
8.B). The lawnmower stops moving
forward when the lever is released.

IMPORTANT

be ignited with the drive disengaged.
IMPORTANT
do not pull the machine backwards with the drive engaged.
CUTTING HEIGHT ADJUSTMENT
5.7
Lower or raise the chassis to cut the
grass at diferent heights.
Do this when the cutting means is stationary.
• "I" type adjustment.
The cutting height is adjusted by pressing the button
(ig. 9.A) and, using the handgrip (ig. 9.B), lifting
or lowering the chassis to the desired position.
• "Il" type adjustment.
The cutting height is adjusted by using the
designated lever (ig. 9.C) that lifts or lowers
the chassis to the desired position.
EN - 5
The engine must always
To prevent damage to the transmission,
» position.