Wiring The Hood With An Inline Blower - Thermador PROFESSIONAL SERIE Manual De Instalación Y Manteniemiento

Wiring the Hood with an Inline
Blower
Figure 23: Wiring the Hood with an Inline Blower
English 14
7
/
"(22mm)
8
7
"
/
8
(22mm)
Figure 22: Inline Blower
1. Remove the junction box cover.
2. Install 1/2" (13mm) conduit connectors.
3. Run black, white, and green wires (#12 AWG) in 1/2"
(13mm) conduit from power supply to junction box.
4. Connect the power supply wires to the hood wires in
the following order: black to black, white to white, and
green wire to green ground screw on chassis. Use
spring type wire nuts supplied. (Lost or missing wire
nuts should only be replaced with: Spring type wire
nuts, rated for a minimum of (2) # 18ga wires and
maximum of (4) #14ga wires, UL & CSA rated to 600V
and 302° F/ 150° C).
5. Connect the "pigtail" to the connector inside the
junction box.
6. Run (5) wires (#14 AWG) in 1/2" (13mm) conduit from
the inline blower to the second conduit connector.
7. Connect the inline blower to the pigtail wires (Step 6)
as per Figure 23. Connect the inline blower green
(ground) wire to the ground screw in the junction box.
8. Close junction box cover. Check that all light bulbs are
secure in their sockets. Install filters ("Installing Filters,
Grease Trays, and Heat Lamps" on page 15). Turn
power on at service panel, and check lights and blower
operation per Use & Care Manual.