Safety Instructions
Important Safety Instructions
READ AND SAVE THESE INSTRUCTIONS
APPROVED FOR ALL RESIDENTIAL APPLIANCES
FOR RESIDENTIAL USE ONLY
Before you Begin
IMPORTANT: Save these Instructions for the Local Gas
Inspector's use.
INSTALLER: Please leave these Instructions with this unit
for the owner.
OWNER: Please retain these instructions for future
reference.
WARNING:
If the information in this manual is not followed
exactly, fire or shock may result causing property
damage or personal injury.
Do not repair or replace any part of the appliance
unless specifically recommended in the
manuals. Improper installation, service or
maintenance can cause injury or property
damage or void product warranty. Refer to this
manual for guidance. All other servicing should
be done by a qualified technician.
CAUTION:
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two
people must be used in moving the hood to avoid
injury and to avoid damage to the unit or the
floor. Rings, watches, and any other loose items
that may damage the unit or otherwise might
become entangled with the unit should be
removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
English 2
This appliance complies with one or more of the following
Standards:
•
UL 858, Standard for the Safety of Household Electric
Ranges
•
UL 923, Standard for the Safety of Microwave Cooking
Appliances
•
UL 507, Standard for the Safety of Electrical Fans
•
ANSI Z21.1- American National Standard for
Household Cooking Gas Appliances
•
CAN/CSA-C22.2 No. 113, Fans and Ventilators
•
CAN/CSA-C22.2 No. 61, Household Cooking Ranges
It is the responsibility of the owner and installer to
determine if additional requirements and/or standards
apply to specific installations. Always refer to local codes to
ensure all requirements are met.
SAFETY WARNING:
Turn off power circuit at service panel and lock
out panel before wiring this appliance.
Requirement: 120 VAC, 60 Hz 20 A. Allow the
appliance to cool after the power has been
turned off before servicing the appliance.
WARNING:
To reduce the risk of fire use only metal
ductwork.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer — show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Remove all tape and packaging before using the
appliance. After unpacking the appliance, please
recycle the packaging material as all
®
THERMADOR
recyclable. Never allow children to play with
packaging material.
Never modify or alter the construction of the appliance. For
example, do not remove panels or wire covers.
appliance packaging is