Installation; Place Of Installation - Maquina Semplice Manual De Uso

All the operations illustrated in this chapter are to be carried out only
by specialist technicians , who must organize the different operating
sequences and the use of appropriate resources so as to act at all
times with strict application of the current regulations in this matter.
Before the machine is installed, the premises must satisfy the following requirements
The premises must have been prepared
for installing the machine
The premises must satisfy the require-
ments regarding lighting, ventilation and
hygiene.
The surface of the location must be sol-
id, flat (inclination less than 2) and sta-
ble.
The electricity socket must be easily
reached.
25cm
8

Place of installation

3.Installation

.
In the figure below, the minimum distances necessary to carry
out the installation are indicated.
The separation distances are the same for machines with 1, 2
and 3 bowls.
25cm
3.1 Place of installation
The machine must be supervised.
Therefore, it must be installed in a place
where it can be observed by trained
staff.
It is prohibited to install the machine
in locations where it can be reached,
touched and/or activated by persons
other than those specified in section 1.
The machine must work in environ-
32ºC
ments with a temperature of between
20ºC
20ºC and 32 ºC.
There must be space for access to the
machine in order to:
- Allow the operator to act without any
limitation;
- Be able to immediately leave the area if
necessary;
- Allow air to circulate;
25cm