Bosch PMF 250 CES Manual Original página 17

OBJ_BUCH-2653-002.book Page 17 Friday, April 1, 2016 12:32 PM
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for sand-
ing, series Delta
93 mm
Profile sander
BIM plunge cut saw
blade, wood and
metal
HCS plunge cut saw
blade, wood
Bi-metal plunge
cut saw blade,
hardwood
TC plunge cut saw
blade, metal
BIM plunge cut saw
blade, wood and
metal
HM-Riff segment
saw blade
Bosch Power Tools
Material Application
Wooden materials, Separating and plunge cuts; also for sawing close to edges,
Plastic, in corners and hard to reach areas;
Non-ferrous metals example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Wood, Convenient, efficient sanding of profiles up to a diameter of
Pipes/Profile, 55 mm;
Paint, Red sanding sheets for sanding wood, pipes/profiles,
Varnishes, varnishes, fillers and metal
Filler,
Metal
Softwood, Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush cutting a
Plasterboard, copper pipe, plunge cuts in plasterboard
Thin-walled aluminium
Filigree adjustment work in wood;
and non-ferrous metal
example: sawing openings for locks and fittings
profiles,
Thin sheet metals,
Non-hardened nails and
screws
Wooden materials, Separating and deep plunge cuts; also for sawing close to
Soft plastics edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing a
ventilation grid
Hardwood, Plunge cuts in laminated panels or hardwood;
Laminated panels example: installing skylights
Metal, Plunge cuts in severely abrasive materials or metal;
Severely abrasive example: cutting kitchen front covers, easy cutting through
materials, hardened screws, nails and stainless steel
Fibreglass,
Plasterboard,
Cement-bonded fibre
boards
Softwood, Plunge cuts in laminated panels or hardwood;
Hardwood, example: shortening door frames, cutting openings for a
Veneered panels, shelf
Plastic-laminated panels,
Non-hardened nails and
screws
Cement joints, Cutting and separating close to edges, in corners or hard to
Soft wall tiles, reach areas;
Glass fibre reinforced example: removing grouting joints between wall tiles for
plastics, repair work, cutting openings in tiles, gypsum boards or
Porous concrete plastic
English | 17
1 609 92A 2T0 | (1.4.16)