Simplicity SZT275 Manual Del Operador página 15

Cutting Height Adjustment
The cutting height adjust pedal adjusts the mower cutting height.
See Specifications for cutting height adjustment range.
To adjust cutting height:
1. Fully depress the cutting height adjust pedal (A, Figure 13)
until the transport release rod (B) locks the deck into the
highest position (transport position).
2. Remove the pin (C, Figure 13) from the adjustment bracket,
and insert it in the desired hole.
Note: Make sure the pin is inserted into the holes in both upper
and lower plates of the adjustment bracket.
3. Depress the cutting height adjust pedal, move the transport
release rod outward, and slowly release the pedal until it
rests against the pin.
Mower Removal And Installation
Refer to the Mower Deck Manual for instructions on removing
and installing the mower deck.
Mower Deck Leveling
Refer to the Mower Deck Manual for instructions on leveling
the mower deck.
Cargo Bed (select models)
The cargo bed is designed to carry up to 50 lbs (22,7 kg). Slots
in the rear of the bed will accommodate a 2 x 4 or 2 x 6 to help
secure loads during transport.
WARNING
Amputation Hazard
Rotating blades cut off arms and legs. Do not carry riders
(especially children) even with the blades off. They may fall
off or return for another ride when you are not expecting it.
WARNING
Loss of Control and Roll-Over Hazard
Operating with loads in the cargo bed greater than 50 lbs can
be hazardous and cause loss of control and roll-overs.
The cargo bed can be raised to access the engine compartment
without removing it.
To raise the cargo bed
1. Raise the seat (A, Figure 14).
2. Pull up firmly on the rear of the bed (B, Figure 14).
3. When lowering the bed, press down firmly to secure the
rear of the bed in place with the locking clips (D).
To remove the cargo bed
1. Remove the pins (C, Figure 14) securing the front of the
bed to the rider frame.
2. Pull up firmly on the rear of the bed to release the locking
clips (D, Figure 14).
3. Lift and remove the cargo bed from the rider.
CAUTION
To avoid injury, assistance is required when removing or
installing the cargo bed.
To install the cargo bed
1. Position the bed over the engine compartment, aligning the
holes in the front of the bed with the holes in the frame
brackets.
2. Install the pins (C, Figure 14) into the holes.
3. Lower the rear of the bed, pressing down firmly to secure
with the locking clips (D, Figure 14).
CAUTION
To avoid injury, assistance is required when removing or
installing the cargo bed.
Suspension Adjustment (if equipped)
The shock assemblies (A, Figure 15 - front shown, rear similar)
can be adjusted to vary the amount of pre-load applied to the
springs. This allows the operator to customize the ride according
to operator's weight and operating conditions.
Less Pre-Load:
• Light operator weight
• Softer, more cushioned ride
• Best for relatively flat terrain
More Pre-Load:
• Heavy operator weight
• Stiffer, more rigid ride
• Better handling and greater stability on hilly terrain
To Adjust the Spring Pre-Load:
1. Park machine on a flat, level surface. Disengage the PTO,
pivot the ground speed levers out to the START/ PARK
position, and stop the engine.
2. Turn the pre-load adjustment collar (B, Figure 15) to a higher
notch (-) to decrease the pre-load, or to a lower notch (+)
to increase the pre-load. Make sure all shocks are set to
the same amount of pre-load.
15