Parkside PFDS 33 B4 Instrucciones De Funcionamiento página 39

† Loosen the feed roll holder
it anti-clockwise and pull it upwards and
off (see Fig. G).
† On the top of the feed roll
whether the appropriate wire thickness is
indicated. If necessary, the feed roll has
to be turned over or replaced. The sup-
plied welding wire (Ø 0.9 mm) must be
used in the feed roll
wire thickness of Ø 0.9 mm. The wire
must be positioned in the upper groove!
† Erect the feed roll holder
screw clockwise direction.
† Remove the torch nozzle
it clockwise (see Fig. H).
† Unscrew the welding
(see Fig. H).
† Guide the cable assembly
the welding device as straight as possi-
ble (place it on the floor).
by turning
30
, check
29
with the specified
29
30 again and
by turning
7
nozzle
17
away from
13
17
† Take the wire end out of the edge of the
spool (see Fig I).
† Trim the wire end with wire scissors or
a diagonal cutter in order to remove
the damaged, bent ends of the wire
(see Fig. I).
Please note: The wire must be kept
under tension the entire time in order to
avoid a releasing and a roll out! There-
fore it is recommended to carry out the
work with an additional person.
Assembly
GB/NI/IE 39