Beninca CP.RI624N Manual De Instrucciones página 15

4 If push button P on the receiver is pressed again, the LED turns to GREEN colour.
5 If a transmitter code is to be stored on the second channel (9/10 output), press the transmitter push button to be memorised
within 5 sec.
6 If push button P on the receiver is pressed again, the LED turns to ORANGE.
7 If a transmitter with pedestrian function is to be stored in memory, press the transmitter push button to be memorised within
5 sec.
8 If push button P on the receiver is pressed again, the LED switches off and the receiver exits the learning mode.
To reset the receiver:
Cut off power supply, press push button P and, keeping it pressed, power the unit again. The LED switches on with fixed red light,
and after about 5 seconds, the LED starts flashing with alternate colours. Release the push button and the receiver will be reset and
all transmitter codes erased.
1) Cut-off power supply.
2) Manually release the wings, move them to approx. half-stroke and lock them again.
3) Reset power supply.
4) Send a step-by-step control signal by pressing the button or the remote control key.
5) The wings should start an opening movement.
If this is not the case, invert the movement wires of the motor. (1<>2 for motor M1, and 3<>4 for motor M2) and the relevant limit
switch inputs (14<>15 for motor M1, and 16<>17 for motor M2).
���� ����
���� ����
���� ��� ����
���� ����
������
���
Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s
- activate pre-blinking
Perform the operations described below step by step:
Step Press Display
1
PAR
2
TCA
3
040
4
100
5
PRG
TCA
6
PAR
7
Log
8
TCA
9
Pre
10
OFF
11
12
PRG
Pre
13
PAR
TO CHECK CONNECTIONS:
In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches,
control and safety) can be displayed. One segment of the display is linked to each input.
In the event of failure it switches on according to the following scheme.
�����
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the
horizontal segments.
EXAMPLE OF PROGRAMMING
First menu
First function of the first menu
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu
Second menu
First function of the second menu
Press <-> several times to select PRE logic
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
ON
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu and quit programming or wait
30s.
DIAGNOSTICS
Notes
15