Compare Images When Adjusting The Picture - Pioneer KURO PDP-6020FD Manual De Instrucciones

Basic Operations For Television Viewing
03
Picture Image Position
Each input source stores the picture adjustment settings for that view. Although repositioning is available in most
screen views, when the screen is set to Dot-by-Dot, the Position menu is unavailable. Also, depending on the
displayed video, the image position may not change after an adjustment.
To adjust the picture's horizontal and vertical position, follow the steps below.
1 ) Access the
2 ) Select
3 ) Select
4 ) Adjust the vertical and/or horizontal positioning using the arrow buttons.
5 ) Press HOME MENU to exit the menu.
Restore Default Picture
After making multiple adjustments, it may be difficult to reverse improper settings. To restore the factory default
video settings, follow the directions below.
1 ) Highlight
2 ) Press ENTER to continue with the picture reset.
A confirmation screen appears asking if settings should be returned to the factory defaults.
3 ) Use the arrow buttons to highlight
4 ) Press ENTER.
All video settings return to the original default values when selecting options other than OPTIMUM or PC.
When OPTIMUM is selected, video settings for OPTIMUM, AV Selection menus, and Sound Control
settings return to the original default values.

3.4.3 Compare Images When Adjusting the Picture

When adjusting the picture, look for an overall improvement by adjusting each parameter or option one at a time.
Many small adjustments lead to the best picture for your viewing area. As each option changes, refer back to the
previously set image for comparison. This section includes adjustment notes and steps to adjust the flat panel
TV's picture.
Each parameter/option must be adjusted separately. For example, if two options under AV Selection,
PERFORMANCE and MOVIE need adjustment, change/compare one option then save the preferred setting
before moving on to the other option. Below are other guidelines to follow when adjusting the picture.
• Adjustments are available while on the After screen. Trying to make adjustments while on the
a warning message to appear.
• Switch to another parameter/option only from the
another option, the
• Exiting an option from the
button.
• Exiting an option from the
44
En
Option through the Setup
Position
from the Option menu.
Position
Auto Size
Side Mask
HDMI Input
HDMI Control Setting
Orbiter
Video Pattern
H/V Position Adjust
from the submenu.
Reset
from the Picture menu.
Before
data is lost.
Before
After
screen stores the new entry in memory and deactivates the button.
.
: Off
: Off
Yes .
After
screen. If viewing the
screen stores that previous entry in memory and deactivates the TOOLS
Before
causes
Before
screen when selecting