Connect To Broadcast Tv & Other Devices (Dvr, Receiver, Bdr, Etc.); Add Analog (Conventional) And Digital Tv Channels; Connect Your Other Pioneer Equipment - Pioneer KURO PDP-6020FD Manual De Instrucciones

Install Your Flat Panel TV
02
2.5 Connect to Broadcast TV & Other Devices (DVR, Receiver, BDR, etc.)
The type of equipment attached to your flat panel TV determines which panel ports are used. The following
sections explain how to connect broadcast TV and playback equipment such as a DVD player, Surround Sound
system, video recorder, etc. to the panel. If your equipment is not listed, please refer to the operating instructions
that came with the device(s) for connection assistance.

2.5.1 Add Analog (conventional) and Digital TV Channels

Whether a TV station broadcasts in Analog or Digital, your flat panel TV shows the programs as long as the panel
is programmed to accept the signal. To program your panel for broadcast TV, select terminal ANT.
The ANT terminal accepts both analog and digital
broadcasts. Connect a VHF/UHF antenna and/or cable
TV to the panel's rear ANT terminal, then press TV/DTV
on the remote control to toggle between analog and
digital broadcasts. When watching analog TV
channels, you can also use an outdoor antenna for the
clearest analog picture.
If your outdoor antenna uses a 75-ohm coaxial cable
with an F-type connector, plug it into the panel's
antenna terminal on the back.

2.5.2 Connect Your Other Pioneer Equipment

This section provides cabling information for your other Pioneer equipment when combined with the panel. Each
diagram can also be used as a reference tool for non-Pioneer devices but port locations may differ or be unavailable.
SAT IN
When using a cable STB or Satellite STB, plug in to the antenna/cable TV wall outlet using the STB cable provided
with your STB. If your STB has an HDMI terminal, use any of INPUT 4 through INPUT 6 (HDMI terminal) on the
rear or INPUT 7 (HDMI terminal) on the side of the flat panel TV instead of making video connections. If you
connect an antenna cable directly to TV, you must first connect the cable to a splitter. For details, refer to the
operating manual that came with the STB.
26
En
Connect cable or Satellite using STB (Set Top Box):
Satellite antenna
Cable STB/Satellite STB
COMPONENT
AUDIO
VIDEO OUTPUT
OUT
Y
IN
HDMI OUT
P
B
OUT
P
R
T
W
Rear view
In order to watch both analog and
digital broadcasts through your
terrestrial antenna or cable
connection, you must first connect the
antenna cable to a splitter.
T
W
Rear view
Cable STB/Satellite STB
AUDIO
OUT VIDEO OUTPUT
HDMI OUT
T
W
T
W
COMPONENT
Y
IN
P
B
OUT
P
R