BDS Maschinen MAB 1300 Instrucciones De Manejo página 20

P r e p a r a t i o n
M K t o o l / i n d u s t r i a l t o o l h o l d e r
2 0
NOTE
► When using tools with MK4 taper, the tool holder with
retainer must be dismantled .
For further information, see the section Dismantling/
assembling the tool holder .
F i t t i n g t h e t o o l / i n d u s t r i a l t o o l h o l d e r
Before fitting, clean the shank of the tool, adapter or
‹
industrial tool holder and the morse taper (5) of the machine .
Insert the tool from below into the morse taper (5) of the
‹
machine .
NOTE
► When using tools/adapters with MK3 taper, use MK4:3
adapter sleeve .
R e m o v i n g t h e t o o l
Turn the tool until the ejector pin (6) slips into the opening .
‹
Lever the tool out using the ejector pin or loosen the tool by
‹
tapping the ejector pin .
M A B 1 3 0 0