O P E R A T I O N; Activating/Deactivating The Magnetic Clamp; Switching Machine On/Off - BDS Maschinen MAB 1300 Instrucciones De Manejo

O p e r a t i o n

A c t i v a t i n g / d e a c t i v a t i n g t h e m a g n e t i c c l a m p
Sw i t c h i n g m a c h i n e O N/ O F F
M A B 1 3 0 0
A c t i v a t i n g t h e m a g n e t i c c l a m p
CAUTION
► Switch on the magnetic clamp only when the machine is
standing on a magnetic substrate to prevent the magnet
from overheating .
Turn on switch (22) . The indicator lamp in switch (22) lights
‹
up .
Check the magnet clamping force in the magnet
‹
indicator (24). If the magnet clamping force is sufficient,
the MAGNET POWER indicator lamp (24) is green . If the
MAGNET POWER indicator light (24) is red, sufficient
magnet clamping force is not available .
CAUTION
► The maximum magnet clamping force is only available after
switching on the motor .
D e a c t i v a t i n g t h e m a g n e t i c c l a m p
Hold the handle tightly (12) to stop the machine from
‹
slipping .
Turn off switch (22) . The indicator lamp in switch (22) goes
‹
out .
Turn the machine ON using the ON/OFF switch (21) with the
‹
green button (I) and OFF with the red button (O) .
NOTE
► The machine can only be switched on when the magnetic
clamp has been switched on .
► Allow a severely overheated machine to run on at idle speed
for approx . 2 minutes to cool it down .
► The machine switches off automatically in the event of a
power failure or if the magnetic clamp is switched off .
O p e r a t i o n
2 3