Dismantling/Assembling The Tool Holder - BDS Maschinen MAB 1300 Instrucciones De Manejo

St e e l w i t h l o w
NF m e t a l s o r w o r k p i e c e s w i t h a n u n e v e n s u r f a c e
D i s m a n t l i n g / a s s e m b l i n g t h e t o o l h o l d e r
M A B 1 3 0 0
t h i c k n e s s
When drilling into steel of low thickness, an additional steel plate
(minimum dimensions: 4" x 7
be placed under the workpiece . Secure the steel plate to prevent
it from falling .
A special holding device must be used when drilling into NF
metals or into workpieces with an uneven surface .
NOTE
► CS Unitec offers special clamping devices for tubes and
non-magnetic materials in its range of accessories .
D i s m a n t l i n g t h e t o o l h o l d e r
Unscrew and remove the screws of the retainer (3) on the
‹
magnetic foot .
Push the tool holder (2) out of the morse taper with the
‹
ejector pin (G) .
Remove the tool holder with the retainer .
‹
NOTE
► Keep the tool holder with retainer and screws in the
transport case for later use .
A s s e m b l e t h e t o o l h o l d e r
Insert the tool holder (2) from below into the morse taper (5)
‹
of the machine .
Put the retainer into the guide on the magnetic foot and
‹
secure it with the screws .
7 / " x 3 / " [100 x 200 x 20 mm]) must
8 4
P r e p a r a t i o n
1 7