Comet BW Serie Instrucciones Para El Ensamblaje página 25

• Wear clothing and personal protective equipment able to provide adequate protection from any high-pressure
jets and chemical products used.
CAUTION
• In case of operation at very low temperatures, make sure there is no ice inside the pump and pipes.
• Perform the checks required by routine maintenance, with special reference to those relating to the oil.
Carry out the preliminary activities indicated in the manual of the machine in which the pump is integrated;
unless otherwise indicated, with respect to the pump, always remember the following.
a) Replace the oil cap without vent (17) with the oil cap with vent (8) (see Fig. 3). This operation could already
have been performed by the Manufacturer of the machine in which the pump is integrated.
b) With the pump off and completely cooled down, make sure the oil level is at mid-point of the oil level
indicator (10). The oil level can also be checked (except for AX and BX models) by unscrewing the cap with
vent (8): the correct level is between the two notches shown on the dipstick.
For any touch ups, refer to the types of lubricants indicated in the paragraph
" .
DATA
c) Refer to the operation and maintenance manual of the machine in which the pump is integrated and make
sure the suction filter is clean.
CHECKING AND CONNECTING UP TO WATER mAINS
WARNING
• Also follow the instructions contained in the manual of the machine in which the pump is integrated.
• Follow the water mains connection instructions applicable in the country where the machine in which the pump
is integrated is installed.
CAUTION
• Follow the water mains connection instructions shown in the
with special reference to the priming depth and supply pressure and temperature: in case of any doubts,
contact a Skilled Technician.
• The suction of pump must always be equipped with a suitably-sized filter: frequently make sure this is clean.
• Never operate the pump:
- without water supply;
- with salt water or water containing impurities: if this occurs, have it operate for a few minutes with clean
water.
WARNING
• Also follow the instructions contained in the manual of the machine in which the pump is integrated with
special reference to the parts relating to the safety precautions, any use of personal protective equipment
(protective eyewear, ear muffs, etc.) and handling.
• Before starting up the machine in which the pump is integrated, carefully read the machine's manual and this
manual. In particular, make sure you have fully understood how the pump and the machine in which it is
integrated work as regards liquid on/off operations.
• The pump and the machine in which it is integrated are not intended to be used by people (including children)
with reduced physical, sensorial or mental capacities, or who lack the experience and expertise, unless they
are able to benefit, through the intermediation of a person responsible for their safety, from supervision or
instructions concerning the use of the pump and of the machine in which it is integrated.
• Children must be supervised to make sure they do not play with the pump and with the machine in which it
is integrated.
• Special care must be taken when using the pump in environments where there are moving vehicles which could
crush or damage any: delivery pipe, spray gun and nozzle.
STANDARD OPERATION (HIGH PRESSURE)
"S
PECIFICATIONS AND TECHNICAL
"S
PECIFICATIONS AND TECHNICAL DATA
EN
" paragraph,
25