Nailer Operation - Hitachi Koki NV 75AN Instrucciones Y Manual De Seguridad

English
(5) Close the magazine cover fi rst and swing the nail
guide closed.
(6) Lock the knob correctly.
Knob
Nail guide
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 7).
DANGER
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
WARNING
● NEVER point tool at yourself or others in
work area.
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental fi ring.
● Choice of triggering method is important.
Please read and understand "Methods of
Operation" below.
● Before starting work, check the types of
operation to drive nails.
● Never place your hands or feet closer than 8
inches (200 mm) from fi ring head when using.
14
01Eng_NV75AN_US.indd 14 01Eng_NV75AN_US.indd 14
Magazine cover
There are two types of operation to drive nails with this
Nailer.
Use CONTACT ACTUATION MECHANISM or SINGLE
SEQUENTIAL ACTUATION MECHANISM in accordance
with the work to be performed.
Explanation of the various nailing operations
○ CONTACT ACTUATION MECHANISM: First, press
MUST wear safety
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Disconnect air hose from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person;
the push lever against the wood; next, pull the trigger
to drive the nail. Or,
pull the trigger; next, press the push lever against the
wood to drive the nail.
If the trigger is held back, a nail will be driven each
time the push lever is pressed against the wood.
NV75AN is shipped with CONTACT ACTUATION KIT.
When switching from CONTACT ACTUATION KIT
TO SEQUENTIAL ACTUATION KIT, replace to
SEQUENTIAL ACTUATION KIT.
Punch
Sequential actuation trigger kit
Spiral Pin
Contact actuation
trigger kit
2014/11/20 13:11:38 2014/11/20 13:11:38