Loading Nails - Hitachi Koki NV 75AN Instrucciones Y Manual De Seguridad

Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

WARNING
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Pull the knob down and swing the nail guide open.
And open the magazine cover.
Knob
Nail guide
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine Nail holder
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
000Book_NV75AN_US.indb 13 000Book_NV75AN_US.indb 13
)
2
(3) Place the nail coil into the magazine.
Magazine cover
(4) 1 Uncoil enough nails to reach the driving hole.
Magazine cover
Nail Guide
1 Slide in vertical direction possible.
Lift or lower the nail holder to accept diff erent
length nails.
2 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 45
degrees.
1
2
Magazine
Nail holder
Uncoil enough nails to reach the driving hole.
Nail holder
Nails
Magazine
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
First nail
Driving hole
3
2
Feeder Guide surface
4 Pulling the nails to the right, swing the nail guide
closed.
English
3
1 / ", 2"
4
1 1
2 / ", 2 / "
4 2
3"
Guide slot
4
1
13
2014/05/13 18:12:49 2014/05/13 18:12:49