Handle Installation - Jocel JCV-477L Manual De Instrucciones

HANDLE INSTALLATION

The unit must be unplugged before installing the
handle
1. The freezer ships with the handle inside
2. To install the handle, remove packaging and posi-
tion the handle over the door handle posts
3. Once the handle is in position on the posts insert
the small hex screws into the handle bracket and
tighten them with the allen key provided. Turn
until snug but do not over tighten
Operating Instructions
DOOR REVERSAL INSTRUCTIONS
If you fi nd it necessary to reverse the swing of the freezer door, please follow the directions below.
We suggest emptying the unit and placing it on its back before beginning. Place a towel or blanket on the fl oor underneath
the unit to protect it from possible scratches.
After completing the door reversal, ensure that you allow the unit to stand upright and empty for a minimum of four hours
before plugging in.
1. Remove one screw from top hinge cover (A) and then remove top hinge cover.
2. Remove four screws from top hinge (B) and then remove top hinge, top door spindle (C) and top hinge spacer (D).
3. Remove door from unit and set aside. Ensure that you do not damage the bottom door spindles (F).
4. Remove roller caps at bottom of unit (E).
5. Remove four screws each from both bottom hinges and then swap the bottom hinges (J). Ensure that the C-shaped
hinge is on the side of the unit opposite the handle.
To avoid personal injury to yourself and/or property, we recom-
mend someone assist you during the door reversal process.
CAUTION
-13-