Song Selection For Sound Signal - End Of Run; Keyboard Sound Turn On / Off; Call Up Operating Data - OHAUS Frontier FC5714 Manual De Instrucciones

EN-16

4.1.5 Song selection for sound signal - end of run

Proceed as described under point 4.1.1to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "G". with the adjusting knob (1). As
a result, in the display "RPM | RCF" (A-1), the word "SonGo/Sound" appears. After pressing the key "RPM |
RCF" (4), you can select a song with the adjusting knob (1). (See figure 34).
After you have stored the settings (see 4.1.1) you can change back to the normal program mode again by switch
off the centrifuge for a short while.
A-1
4
5

4.1.6 Keyboard sound turn on / off

Proceed as described under point 4.1.1to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "B". with the adjusting knob (1). As
a result, in the display "RPM | RCF" (A-1), the word "ON/BEEP " appears. After pressing the key "RPM | RCF"
(4), you can turn the keyboard sound (On) or (Off) with the adjusting knob (1). (See figure 39).
After you have stored the settings (see 4.1.1) you can change back to the normal program mode again by switch
off the centrifuge for a short while.
A-1
4
5

4.1.7 Call up operating data

ATTENTION:
This should only be performed by advanced user or service engineer.
In the mode "Basic Adjustments" you can call up the operating data of the centrifuge. Please proceed as
described under point 4.1.2 to enter this program mode. Press the key "Accel/Decel" (5). In the display "Acc/Dec"
(A-2) the word "Service" flashes.
With the adjusting knob (1) the different information can be accessed:
A= previous starts of the centrifuge
Frontier TM Centrifuge FC5714/FC5718/FC5718R/FC5816/FC5816R/FC5916/FC5916R
A-2
A-2
Figure. 34
Figure. 35
1
1