Bosch GTS1031 Instrucciones De Funcionarniento Y Segurida página 13

10. Lower the front of the guard assembly 4 until
the metal "fork" is parallel with the table (Fig. 8).
11. Press down on the guard release lever 5 until
you feel and hear it snap into the locking posi-
tion. Check that the guard assembly is securely
connected (Fig. 8).
ATTACHING THE ANTI-KICKBACK DEVICE
12. Attach the Anti-Kickback Device 7 into the flat re-
cessed area 8 of the riving knife 2 (Fig. 9).
13. Squeeze the compression pads 9 while nesting
the device into the flat area (Fig. 9).
14. Release the compression pads such that the
Anti-Kickback Device locks onto the riving knife
immediately behind the guard assembly. Check
that the attachment pin is securely connected
into locking hole. Carefully raise and lower the
pawls 10 - when letting go, the spring-loaded
pawls must come down and contact the table in-
sert (Fig. 9).
Hint: Position the Anti-Kickback Device behind the flat
recessed area and slide it towards the front until it
drops into the recessed area - then release the com-
pression pins.
Note: The two attachments are independant of each
other, so the Anti-Kickback Device can be attached
before the Guard Assembly.
|
7
10
-13-