Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LEADING
END
The end oftheworkpiece
which, during a riptype
operation,
ispushed into the cutting tool first.
MOLDING
Anon-through
cutwhich p roduces aspecial shape
inthe workpiece
used f or j oining ordecoration.
NON THRU-SAWtNG
Any cutting operation
where t he blade d oes n ot e x-
tend through the workpiece
(e.g. Dado, Rabbet).
PUSH S TICK
Adevice u sed tofeed theworkpiece
through the
saw during narrow r ipping-type
operation
and helps
keep t he operator's
hands well away f rom the blade.
Use the Push S tick f orrip widths less than 6inches
and more t han 2inches.
PUSH BLOCK
A device used for ripping-type
operations too narrow
to allow use of a Push Stick. Use a Push Block for
rip widths less than 2 inches.
RABBET
A notch in the edge of a workpiece.
Also called an
edge dado.
RIPPING
A cutting operation along the length of the workpiece
cutting the workpiece
to width.
REVOLUTIONS
PER MINUTE (R.RM.)
The number of turns completed
by a spinning object
in one minute.
Tools Needed
For Assembly
And Adjustment
HEX"L" WRENCH
(Supplied-insert Plate)
2 IV]iV]
COMBINATION SQUARE
COMBINATION SQUARE MUSTBETRUE
PHILLIPS S CREWDRIVER
STRAIGHT EDGE OFBOARD
3/4" T HICK. THiSEDGE
MUST BEPERFECTLY
DRAW LIGHT LiNE ON
STRAIGHT.
BOARDALONG THIS EDGE. '_"--,.f_L
/
SHOULDBENO GAPOR OVERLAP
HEX"L" WRENCH
HERE WHEN SQUARE I SFLIPPED
(Supplied-Tool Adjustment)
OVER IN DOTTED POSITION.
5 IV]iV]
_
isconnect
plug from power source before performing
any assembly, adjustment
or repair
to avoid possible injury.
-8-
Publicidad
Tabla de contenido
