Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING
THE TABLE
SAW
If table saw is to be used in a permanent
location, it
should be fastened securely to a firm supporting sur-
face such as a stand or workbench,
using the four
mounting
holes 6 (Fig. 16).
1. If mounting to a workbench,
the base should be
bolted securely using 1/4" hex bolts (not included)
through mounting holes 6.
Hint: If workbench
is 3/4" thick, bolts will have to
be at least 3-1/2" long - if workbench
is 1-1/2"
thick, bolts should be at least 4-1/2" long.
2. Locate and mark where the saw is to be mounted,
relative to holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through work-
bench.
4. Place table saw on workbench
aligning holes in
base with holes drilled in workbench.
5. Insert four (4) 1/4" dia. bolts through holes in base
and supporting
surface; then secure with (4) 1/4"
flat washers and (4) 1/4" hex nuts.
4
RiP FENCE
STORAGE
-16-
Publicidad
Tabla de contenido
