Bosch GTS1031 Instrucciones De Funcionarniento Y Segurida página 23

Ocultar thumbs Ver también para GTS1031:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The Main Barrier Guard component
can be quickly
attached and detached
through the use of a quick
release lever. The guard is attached by seating the
crossbar into the top of the Riving Knife and engag-
ing the locking lever. Following
this process
in re-
verse, the guard can be easily removed for special
operations
such as dados or rabbets.
The Anti-Kickback
Device can be easily attached by
aligning the attachment
pin with the hole in the rear
of the riving knife.
It can be easily removed by de-
pressing the compression
pads on either side of the
Anti-Kickback
Device and lifting it away.
The Riving Knife can be easily adjusted
to one of
three heights
by removing
the table insert, raising
the blade to its full height and releasing
the riving
knife release lever at the base of the Riving Knife.
The Riving Knife should be locked in its highest po-
sition for use with the Main Barrier Guard and Anti-
Kickback
Device.
It can be adjusted
to its middle
position for non-through
cuts and for use as a mate-
rial splitter without the Main Barrier Guard and Anti-
Kickback Device.
In the event that the Riving Knife can not be used
for a specific cut, it can be adjusted to its lowest po-
sition, thus placing
it 1" above the surface of the
table (while the blade is at its full height).
SYSTEM
STORAGE
When not in use, the Main Barrier Guard and Anti-
Kickback Device can be stored under the right side
table extension.
Use of all the components
of the
Smart
Guard
System,
including
Main Barrier
Guard,
Anti-Kickback
Device,
and
Riving
Knife is highly
recommended
to provide
protection
against accidents
and injury.
1. Slide the front of the Main Barrier Guard assembly
up and into the U-bracket
at the front right side of
the saw (Fig. 33).
2. Pivot the rear of the guard down and onto the
mounting bracket.
3. Lock the Main Barrier Guard assembly
into place
in the same manner as you would attach it to the
Riving Knife.
4. Locate the Anti-Kickback
Device storage location
just above the Dust Chute on the back of the tool.
Attach the Anti-Kickback
Device to the hanging
bracket in the same manner that it attaches to the
Riving Knife (Fig. 34).
-23-

Publicidad

Tabla de contenido
loading

Tabla de contenido