Setting Up Your Machine - Husqvarna H Class 200S Guia Del Usuario

SETTING UP yOUR MACHINE

1. Wipe off excess oil in the needle plate and bed areas.
2. FOOT CONTROL
Use Model YC-483E with this sewing machine.
Push foot control plug into plug connector socket and connect the power cord plug to
power supply outlet.
3. POWER/ LIGHT SWITCH
Your machine will not operate unless the power/light switch is turned on. This same
switch controls both machine power and sewing light.
When leaving the machine unattended or servicing the machine, remove the power cord
plug from the power supply outlet.
4. OPENING FRONT COVER
To open front cover, pull it to the right and down towards you.
5. OPENING WORKING TABLE
To open working table, pull the release lever toward you with your right hand. Pull the
cover toward you to open.
Close cover before operating machine.
Illustration
* : Plug connector socket
I
* : Power/light switch
II
* : Release lever
III
* : Working table
IV
* : Front cover
V
10